Blazer seat question - Please help! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

David Johnson · 12-18-2007, 05:11 PM

I have a 70 blazer with a half cab and was thinking of putting in a truck bench seat. Will a factory 67-72 truck bench bolt right in with no drilling? How about a 64-66 style with the fold over back? Any help would be great.

bouncytruck · 12-18-2007, 05:36 PM

I believe a 67-72 bench will, but I don't know about the earlier model. I'd assume not since the trucks were so completely different.

JimKshortstep4x4 · 12-19-2007, 12:05 AM

Drilling will be necessary as the hole spacing is different, (having installed Blazer seats in a truck where the existing holes could not be used).

Jim

**jaros44sr** · 12-19-2007, 01:50 AM

Your going to have to open up the back of your torsion boxes, that may be a challenge w/o snapping bolts. Floorboards are the same, so it should fit. Lucky guy to have a 1/2 top...

12-18-2007, 05:11 PM	#1
David Johnson Registered User Join Date: Dec 2004 Location: Shawnee, OK Posts: 614	Blazer seat question - Please help! I have a 70 blazer with a half cab and was thinking of putting in a truck bench seat. Will a factory 67-72 truck bench bolt right in with no drilling? How about a 64-66 style with the fold over back? Any help would be great.

12-18-2007, 05:36 PM	#2
bouncytruck SKINNY TIRES RULE! Join Date: Sep 2001 Location: Bothell, WA Posts: 11,038	Re: Blazer seat question - Please help! I believe a 67-72 bench will, but I don't know about the earlier model. I'd assume not since the trucks were so completely different. __________________ bouncytruck 1972 K5 The Hauler 1994 K1500 Suburban The Daily2010 Kia Soul Wife's Ride2014 Fiat 500L

12-19-2007, 12:05 AM	#3
JimKshortstep4x4 Senior Member Join Date: Jul 2001 Location: Muskegon,MI,USA Posts: 6,026	Re: Blazer seat question - Please help! Drilling will be necessary as the hole spacing is different, (having installed Blazer seats in a truck where the existing holes could not be used). Jim __________________ 1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC

12-19-2007, 01:50 AM	#4
jaros44sr Senior Member Join Date: May 2006 Location: Philadelphia, Pa. 19454 Posts: 9,780	Re: Blazer seat question - Please help! Your going to have to open up the back of your torsion boxes, that may be a challenge w/o snapping bolts. Floorboards are the same, so it should fit. Lucky guy to have a 1/2 top... __________________ Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.