|
01-28-2003, 10:14 PM
|
#1 |
|
Registered User
Join Date: Jan 2003
Location: Beckley WV
Posts: 1
|
Prostreet on a budget
What is the maximum tire size and the backspacing requirements do I need to prostreet my "78 Chevy without narrowing the rear end or frame rails
|
|
|
|
01-28-2003, 10:27 PM
|
#2 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,066
|
I've seen the hangers flipped from side to side, to the inside of the frame-rails. Widen the wheeltubs & get some wide wheels w/the right offset & you don't have to narrow the rear end.
I did this w/my 67 w/an un-narrowed 12 bolt, coil spring rear. I used 15x14" steelies w/10" of backspace & widened my tubs to 20". It's easier w/the coil set-up but can be done w/leafs.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
01-29-2003, 08:19 PM
|
#3 |
|
Iamnotanofficerofthelaw
Join Date: Feb 2002
Location: Turlock, California
Posts: 352
|
Damn Riptide, I wish I could do that!
__________________
~Paul~ '96 C1500 Silverado- Vortec 5.0L/Exhaust/Stock  '87 S-10 Ext Cab- 2.8L/700r4 KIA Caught fire 12/7/03 |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
