|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-02-2008, 03:38 PM
|
#1 |
|
Registered User
Join Date: Jun 2008
Location: Dallas, texas
Posts: 2
|
Need Help, interchangable parts 1968 C10
I am starting a new build and it happens to be my first truck. I just bought a 1968 C10 long bed and want to know if the rear end, front spindles, from a 1985 Cherolet Van fit my 1968 c10?
Thanks |
|
|
|
07-02-2008, 05:40 PM
|
#2 |
|
Senior Member
Join Date: Sep 2004
Location: Terrell, TX
Posts: 1,967
|
Re: Need Help, interchangable parts 1968 C10
Welcome to the board....first the rear axle issue. You have a coil spring setup now right? The newer axles were mostly leaf sprung so it's not a direct bolt in. You'll be grinding & welding for sure....we've done this on 2bits truck and it was quite the job.
On the spindles I am not sure, but if they are the same as the 73-87 trucks the whole front end will swap in to take the place of yours.
__________________
Kelly '05 GMC Sierra SLE Z71 Bone stock except for new bed rail caps. |
|
|
|
|
07-02-2008, 06:27 PM
|
#3 |
|
Registered User
Join Date: Oct 2005
Location: Overland Park, Ks.
Posts: 5,229
|
Re: Need Help, interchangable parts 1968 C10
Measure the width. Usually the van parts are much wider.
|
|
|
|
|
07-03-2008, 04:25 PM
|
#4 |
|
Registered User
Join Date: Jun 2008
Location: Dallas, texas
Posts: 2
|
Re: Need Help, interchangable parts 1968 C10
Thanks ..looking forward to being a part of this forum. This is my first truck so I'm sure I will end up having alot of questions. Any information is greatly appreciated.
Thanks again Last edited by lunaelement; 07-03-2008 at 04:26 PM. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
