|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
10-25-2008, 11:39 AM
|
#1 |
|
I am a Referee of life.
Join Date: Jun 2000
Location: Greensboro N.C.
Posts: 13,992
|
Re: does hei use the coil from points ignition
Member shifty did a write up on going to
HEI in a 6.It has parts # for the connector in the firewall and good info.I did mine in about 30 min.It took longer to collect the wires,connector and such than to put it in.I turned the rotor the same as the old points dist and it started right up.Within 2* of time.You should also install new plugs since you will want to regap.I think I gapped mine(250 6) at 40 but will probably go to 45 next time.
__________________
The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion. You can't fix stupid,not even with duct tape. "My appearance is due to the fact that "GOD" does punish you for having too much fun!" Barrett-Jackson has perfected alchemy,they make rust into gold! "You can lead a horse to water but you can't saddle a duck" "Cleverly disguised as a 'Responsible Adult' "Sometimes your Knight in shining armor is just a retard in tinfoil" Last edited by PanelDeland; 10-25-2008 at 11:41 AM. |
|
|
|
| Bookmarks |
|
|
Hybrid Mode
