help with 68 bench seat - The 1947 - Present Chevrolet & GMC Truck Message Board Network

greenhorn · 01-13-2009, 11:10 AM

If anyone can help me I'm looking for a picture or instructions how to assemble the seat latch for a 68 bench seat. Thanks for any help you can give

**LockDoc** · 01-13-2009, 12:45 PM

-
If you have any questions on these let me know. Your connecting rod may not have the offset in the middle of it and may have an "S" hook instead of the spring. These aren't the best pictures but the seat was still in the truck.

LockDoc

greenhorn · 01-13-2009, 11:10 PM

thanks for the help.
it is different then mine i have a straight rod going across
the bottom of the seat
with a spring bolted to the center of the floor
and a wierd looking clip at the end of it.
it only unhooks the driver side slide and the
passenger side is movable by pushing the pin
it doesn't look broke just not hooked up right
i'll snap a couple of pictures tommarow
and thanks for the help

**LockDoc** · 01-14-2009, 12:32 AM

Quote:

Originally Posted by greenhorn

thanks for the help.
it is different then mine i have a straight rod going across
the bottom of the seat
with a spring bolted to the center of the floor
and a wierd looking clip at the end of it.
it only unhooks the driver side slide and the
passenger side is movable by pushing the pin
it doesn't look broke just not hooked up right
i'll snap a couple of pictures tommarow
and thanks for the help

Sounds good, pics would help. I have seen a few different setups and a couple of redneck conversions... Meaning no disrespect to the rednecks on here...

LockDoc

01-13-2009, 11:10 AM	#1
greenhorn Registered User Join Date: Jun 2007 Location: northeast pa Posts: 30	help with 68 bench seat If anyone can help me I'm looking for a picture or instructions how to assemble the seat latch for a 68 bench seat. Thanks for any help you can give

01-13-2009, 12:45 PM	#2
LockDoc The Older Generation Join Date: Aug 2006 Location: Montezuma, Iowa Posts: 25,852	Re: help with 68 bench seat - If you have any questions on these let me know. Your connecting rod may not have the offset in the middle of it and may have an "S" hook instead of the spring. These aren't the best pictures but the seat was still in the truck. LockDoc Attached Images __________________ Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 - Last edited by LockDoc; 01-13-2009 at 12:54 PM.

01-13-2009, 11:10 PM	#3
greenhorn Registered User Join Date: Jun 2007 Location: northeast pa Posts: 30	Re: help with 68 bench seat thanks for the help. it is different then mine i have a straight rod going across the bottom of the seat with a spring bolted to the center of the floor and a wierd looking clip at the end of it. it only unhooks the driver side slide and the passenger side is movable by pushing the pin it doesn't look broke just not hooked up right i'll snap a couple of pictures tommarow and thanks for the help



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.