|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-01-2003, 12:32 AM
|
#26 |
|
Registered User
Join Date: Nov 2002
Posts: 461
|
would seem to be easier to weld up the holes and redrill the correct spacing.? possibility? know a good welder?
good luck! 
|
|
|
|
03-01-2003, 12:55 AM
|
#27 |
|
Project92 SWB stepside
Join Date: Feb 2003
Location: Louisville KY
Posts: 4,792
|
That would be a idea that I have thought about. The problem is that Im not sure that I can pull it off and not F up the powder coating that I have on. I would also prefer that I could cover up any bare welds with maybe a paint or something to keep from showing the repair. Im going to look at it a little closer tommorrow and see what is best.
__________________
92 C1500 stepside 496 Stroker Competiton Engineering Ladder bars/QA1 coilovers. Dana 60 rear with 4.10 gear and posi. Bonspeed Palisade 20x12 in rear w/335/30/20 and 20x8.5 front w/245/40/20. 5/8 drop with Belltech springs/DJM spindles/drop shocks. WWS Progress thread http://67-72chevytrucks.com/vboard/s...d.php?t=140448 |
|
|
|
|
03-07-2003, 11:53 PM
|
#28 |
|
Project92 SWB stepside
Join Date: Feb 2003
Location: Louisville KY
Posts: 4,792
|
I have spoke with Bill Turner tonight and we beleive we have found the correct shaft. This may turn out to be a good ending after all??
__________________
92 C1500 stepside 496 Stroker Competiton Engineering Ladder bars/QA1 coilovers. Dana 60 rear with 4.10 gear and posi. Bonspeed Palisade 20x12 in rear w/335/30/20 and 20x8.5 front w/245/40/20. 5/8 drop with Belltech springs/DJM spindles/drop shocks. WWS Progress thread http://67-72chevytrucks.com/vboard/s...d.php?t=140448 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
