Progress pics on the 48 s-10 swap - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Thadious · 05-21-2009, 10:40 PM

Easiest place I found to figure where to cut the horns back to....

If you look on the underside of the frame just infront of the steering box, you should find a 1/2" hole. About 1/2" or so infront of that works well. I cut and boxed mine ahead of time and ended up cutting them right back to there and noticed that the same hole was in the exact same location on both sides.

Not that it should make much of a difference but I'm working my body drop the same is Jeffs51chevy... so about 6-8" off the ground at the back of the front fenders.

Cheers,
Ted.

05-21-2009, 10:40 PM	#1
Thadious Registered User Join Date: Sep 2008 Location: Creston, BC Canada Posts: 369	Re: Progress pics on the 48 s-10 swap Easiest place I found to figure where to cut the horns back to.... If you look on the underside of the frame just infront of the steering box, you should find a 1/2" hole. About 1/2" or so infront of that works well. I cut and boxed mine ahead of time and ended up cutting them right back to there and noticed that the same hole was in the exact same location on both sides. Not that it should make much of a difference but I'm working my body drop the same is Jeffs51chevy... so about 6-8" off the ground at the back of the front fenders. Cheers, Ted. __________________ '51 Chevy Build - In the design stages Aut viam inveniam aut faciam - I will either find a way or make one. If you don't have time to do it right the first time, when will you... My new build - https://67-72chevytrucks.com/vboard/...70#post8958970



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.