|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
06-04-2009, 06:14 AM
|
#1 |
|
ENGINE BUILDER
Join Date: Apr 2006
Location: Shortsville n.y.
Posts: 344
|
Re: seperating pistons and rods
You need a press to get them off the rods. The machine shop can use a rod heater to install the pistons or I have a special OTC setup that reaches inside the piston and holds the rod and presses the pin through without damaging the piston.
__________________
JIM ZAG |
|
|
|
| Bookmarks |
|
|
Hybrid Mode
