pulley questions - The 1947 - Present Chevrolet & GMC Truck Message Board Network

mrein3 · 07-06-2009, 12:43 PM

When I got my truck 15 years ago it was a mutt. Body, chassis, engine, tranny, everything - including engine pulleys - were from different trucks.

I was constantly messing around with broken alternator mount bolts and alternator mount arms.

I finally got a complete set off of a known factory configuration. That solved ALL my problems.

I would look in the parts section for a complete set, swap them all, and never look back. I would NOT mess with spacing them out with spacers or washers.

07-06-2009, 12:43 PM	#2
mrein3 Registered User Join Date: Feb 2000 Location: Center City, MN, USA Posts: 3,254	Re: pulley questions When I got my truck 15 years ago it was a mutt. Body, chassis, engine, tranny, everything - including engine pulleys - were from different trucks. I was constantly messing around with broken alternator mount bolts and alternator mount arms. I finally got a complete set off of a known factory configuration. That solved ALL my problems. I would look in the parts section for a complete set, swap them all, and never look back. I would NOT mess with spacing them out with spacers or washers. __________________ '70 cab, '71 chassis, 383, TH350, NP205. '71 Malibu convertible '72 Malibu hard top Center City, MN



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.