|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
10-19-2009, 12:57 AM
|
#16 |
|
70 Chevrolet=Obsession
Join Date: Jun 2009
Location: nice ca
Posts: 1,067
|
Re: New 67 swb, new to board, questions....
Welcome! From Lake County California. One thing you might check. Crawl under the front of your truck. If the spindle comes out of the bottom of the carrier, you got stock spindles. If it comes out midway between the top and bottom of the carrier, you got drop spindles. You said you want to go lower in the rear but you don't want to notch the frame. The accepted lowering limit without a notch is 5" from stock height. Good luck with your truck!
__________________
 I'm Just like my truck. Old, Ugly and Grouchy. Except my truck starts easily in the morning and doesn't smoke! IT'S NOT EASY BEING GREEN! -Kermit the frog 1970 Chevrolet C-10 Longbed Stepside : 350, Muncie M20, 3.08 GM corp. positraction Forest green exterior/light green interior(Where all my money goes) 1996 Toyota Corolla (Parts runner) Last edited by unclewatts; 10-19-2009 at 12:59 AM. |
|
|
| Bookmarks |
|
|
Threaded Mode