|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-19-2010, 10:23 AM
|
#1 |
|
Registered User
Join Date: Feb 2010
Location: Richmond
Posts: 30
|
Hey all, new to the forum with a spring question
I want to lower my 86 c10 2 inches and was told I would not be able to get it back into alignment afterwards. There are no plans for spindles as this is the only drop I will do. Is there any truth in this?
Thanks Jesse
__________________
The ultimate swear! Your mother is a *beep beep beep*ing*beep*lorem ipsum*beep beep beep*admiumvenium*beep beep beep beep*turolagulio*beep beep beep beep beep beep beep beep* hippopotamus*beep beep beep beep beep beep*beep beep beep* Daniel Radcliffe *beep beep beep beep* with a bucket of *beep beep beep beep* in a castle far away where no one can hear you *beep beep beep beep beep beep* soup *beep beep beep* with a bucket of *beep beep* Mickey Mouse *beep beep* with a stick of dinomite *beeeeeepppp* magical *beep beep beep beep* ALAKAZAM! |
|
|
|
02-19-2010, 10:48 AM
|
#2 |
|
Happy to be here
 
Join Date: Mar 2000
Location: Cypress, TX
Posts: 39,021
|
Re: Hey all, new to the forum with a spring question
None at all. Be sure to take it too a quality shop to do the work. If alignment is a concern, I would go with spindles rather than springs.
__________________
Follow me on Facebook and Instagram @N2trux.com Articles- "Jake" the 84 to 74 crewcab "Elwood" the77_Remix 85 GMC Sierra "Scarlett" "Refining Sierra" |
|
|
|
|
02-19-2010, 12:50 PM
|
#3 |
|
Watch out for your cornhole !
 
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: Hey all, new to the forum with a spring question
Your alignment guy is trying to get out of doing the job. You can align them just fine with 2 inch drop springs.
__________________
I'm on the Instagram- @Gearhead_Kevin |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
