motor mounts/frame mounts

[Captainfab]

A couple pics might help. The '63-'66 V8 and some 6cyl mounts went in the rear location. The '67-'72 small block mounts were in the forward location. The 292's used one of each, passenger side forward, drivers side rear.

Originally Posted by low79fx

What do you mean by lean? I had a problem getting the perches in on mine .I have a 350sbc that the PO installed,the perches were installed backwards i.e.lft.to rght.,rght.to lft. placing engine about an inch back and thus putting driveshaft tight between tranny and rear end.No slip forward clearance.I swapped them around it did give me the clearance needed at the drive shaft but it was hell lining up driver side mount to frame holes.Did I need different mounts.I am not sure exactly what mounts I actually have but they were tight fitting.Oh they are placed in the front mounting holes.