|
07-12-2011, 12:02 AM
|
#1 |
|
Registered User
 
Join Date: Feb 2010
Location: charlotte nc
Posts: 302
|
Silly queation
How in the world do you measure a driveshaft?
Posted via Mobile Device |
|
|
|
07-12-2011, 12:21 AM
|
#2 |
|
Registered User
Join Date: Mar 2000
Location: Blue Ridge, Tx
Posts: 1,172
|
Re: Silly queation
You don't know, so its not silly. Measure center to center of the front/rear joints. If you have a slip yoke, IMO, you want about 2/3's to 3/4 engagement of the slip on the trans output.
Posted via Mobile Device
__________________
Fawker Fab three seater rock crawler buggy 498 BBC/SM465/203/205 doubler, propane, 5.13's, 42" PB Rockers '66 C10 - The new hot rod '77 3+3 Dually - 12 valve 4wd conversion tow rig project '28 Ford 2 door sedan street rod RevLimit Offroad "Hang on beer, we can do this." |
|
|
|
|
07-12-2011, 12:56 AM
|
#3 |
|
Registered User
Join Date: Jul 2009
Location: cleburne texas
Posts: 174
|
Re: Silly queation
If youre having one custom made ask the builder....with the suspension loaded take youre measurements ............ usually center u joint to center u joint .... last one i had done was end to end ..everyone is different
|
|
|
|
|
07-12-2011, 01:00 AM
|
#4 |
|
Registered User
Join Date: Sep 2010
Location: los angeles
Posts: 1,134
|
Re: Silly queation
http://www.dennysdriveshaft.com/how_to_measure.html
I printed this out, and filled it in when I had a driveshaft made locally...the driveshaft dude was appreciative. |
|
|
|
|
07-12-2011, 07:52 AM
|
#5 |
|
Registered User
Join Date: Feb 2010
Location: charlotte nc
Posts: 302
|
Re: Silly queation
How much of the nose of the drive shaft should enter my trans... Does it make a defference on length since it's a manual trans and not an auto
Posted via Mobile Device |
|
|
|
|
07-12-2011, 08:32 PM
|
#6 |
|
Registered User
Join Date: Sep 2010
Location: los angeles
Posts: 1,134
|
Re: Silly queation
I don't remember how much went in, because I don't remember how long the shaft is, but I've enclosed a pic of my old shaft, in the old 3spd...it looks like 1 1/8" of shaft sticks out, with weight on the suspension. My new driveshaft, in my new trans has about the same ammount of shaft sticking out.
|
|
|
|
|
07-12-2011, 09:13 PM
|
#7 |
|
Watch out for your cornhole !
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: Silly queation
My driveshaft shop has me bottom the yoke into the trans then back it out 3/4 of an inch. Then measure center to center of the u joints for length.
__________________
I'm on the Instagram- @Gearhead_Kevin |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
