The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 07-20-2011, 06:04 PM   #1
J Knight
Registered User
 
J Knight's Avatar
 
Join Date: Jun 2011
Location: Baytown TX
Posts: 2,219
Re: column to floor shifter

Quote:
Originally Posted by craig@ridetech.com View Post
When I did the swap from 3spd to TH350 auto, I bought a floor shifter kit from Gennie Shifter. Wasn't hard at all. Like posted before, you will remove the linkage from the previous column shift to get it out of the way. With the Gennie kit, I bolted the new hardware onto the trans, put it back in position and marked the underside of the tunnel where the shift lever would now be coming through, pulled the trans back out of the way. Dilled some pilot holes from the bottom to mark the area that needed cut out, then from the inside used a die grinder to connect the dots. Put the trans back in. Attached the shif lever, adjusted the new linkage and was in business. Hope that helps.
Just to add a little some auto floor shifts mount to tranny like stated and some mount to floor.
__________________
John
82 Chevy Silverado 350ci/TH350
J Knight is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:14 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com