|
07-31-2011, 11:21 PM
|
#1 |
|
Registered User
Join Date: Jun 2011
Location: Phoenix Arizona
Posts: 4
|
New Need Help!!!
I am new to this forum and square body trucks. I have an 83 c10 SB that I am about to lower with Mcgaughy's 4/6. Spindles and springs in the front and flip in the back. The problem that I am running into is in the front. I want to run a 15inch rim and currently the ones that i have on my truck are the stock rally rims which are 15x8 with a 41/2 Back Spacing. I was told that I will not be able to run this as it will rub on control arms. I have seen alot of 73-87 running 15s, want to know the best thing to do to make it work. Should I go to 15x7 or 15x 6 with different back spacing or what would be the best?
|
|
|
|
07-31-2011, 11:28 PM
|
#2 |
|
Registered User
Join Date: Nov 2009
Location: Sonora California
Posts: 860
|
Re: New Need Help!!!
Are those a 3" drop spindle?
|
|
|
|
|
07-31-2011, 11:41 PM
|
#3 |
|
Registered User
Join Date: Jun 2011
Location: Phoenix Arizona
Posts: 4
|
Re: New Need Help!!!
Sorry, 2 1/2
|
|
|
|
|
07-31-2011, 11:51 PM
|
#4 |
|
BAD BOW-Silverado XST
Join Date: May 2000
Location: Senior Member from Austin, TX
Posts: 6,431
|
Re: New Need Help!!!
Welcome to the site. You can shave a little off the control arm with a grinder. I'm not sure if aftermarket tube a-arms may work. The tube arms seem to have more clearance.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
