|
08-24-2011, 06:43 PM
|
#1 |
|
Registered User
Join Date: Jul 2011
Location: owasso oklahoma
Posts: 20
|
block hugger headers
Hello everyone! Have a problem with my block hugger headers not fitting on 52 chevy pickup. Have a mustang II front end and have not welded motor mounts in yet but no room for clearence. Anyone have any suggestions or have a type of header that works? THX Jason
|
|
|
|
08-24-2011, 07:13 PM
|
#2 |
|
Registered User
Join Date: Feb 2009
Location: Glendale, Az
Posts: 1,062
|
Re: block hugger headers
what engine?
|
|
|
|
|
08-24-2011, 08:09 PM
|
#3 |
|
Registered User
Join Date: Oct 2010
Location: mt vernon, oh
Posts: 868
|
Re: block hugger headers
if you have not welded in motor mounts , how is there no clearance?
put headers on and weld mounts to fit... |
|
|
|
|
08-24-2011, 09:33 PM
|
#4 |
|
Registered User
Join Date: Jul 2011
Location: shingle springs, calif
Posts: 771
|
Re: block hugger headers
These are from a '52 chevy, and sometimes you have to cut the frame to get the steering shaft to clear.. using block hugger headers..
|
|
|
|
|
08-24-2011, 10:39 PM
|
#5 |
|
Registered User
Join Date: Feb 2010
Location: gresham oregon
Posts: 806
|
Re: block hugger headers
i used a patriot H8065. it doesnt look like it from the picture but there is about 1 inch clearance around the steering shaft.i used the stock frame and a mustang II ifs with no modications. draw back is that they are about $275 uncoated
|
|
|
|
|
08-24-2011, 10:42 PM
|
#6 | |
|
Registered User
Join Date: Jul 2011
Location: owasso oklahoma
Posts: 20
|
Re: block hugger headers
Quote:
|
|
|
|
|
|
08-24-2011, 10:43 PM
|
#7 |
|
Registered User
Join Date: Jul 2011
Location: owasso oklahoma
Posts: 20
|
Re: block hugger headers
383 stroker
|
|
|
|
|
08-24-2011, 10:46 PM
|
#8 |
|
Registered User
Join Date: Jul 2011
Location: owasso oklahoma
Posts: 20
|
Re: block hugger headers
well my helper was getting ready to weld the motor mounts and he said that he thinks that if i had block headers that the first and last pipe went behind the two center he would have room.
|
|
|
|
|
08-24-2011, 10:50 PM
|
#9 |
|
Registered User
Join Date: Jul 2011
Location: owasso oklahoma
Posts: 20
|
Re: block hugger headers
my headers are different than yours. the first and last pipe are in front of there two center pipes.. yours looks great!! no problems with yours?
|
|
|
|
|
08-24-2011, 11:54 PM
|
#10 |
|
Registered User
Join Date: Jul 2011
Location: shingle springs, calif
Posts: 771
|
Re: block hugger headers
Here is a picture of the steering and motor mounts in a '51 suburban, the frame should be the same as your's.. does this give you a better look?
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
