Cut front springs or lower front body mounts??

[YBNORML]

Originally Posted by El Campo

Hmm ok, good advice. I will most certainly think about this. I had heard that cutting your springs make the ride go bad but if others have not found that to be so then it is indeed an attractive option

I have not noticed a difference in ride quality when cutting only 1 full coil. However you do run the possibility of hitting the control arm bumpstops if you cut too much. It all depends on your setup.

On my 2wd 72 blazer I am running a 2-1/2" drop spindle with 1" drop springs. It was not low enough so I cut 1 full coil. It does not ride any different than it did before I cut.

Jason
Posted via Mobile Device