|
09-21-2012, 08:28 PM
|
#1 |
|
Account Suspended
 Join Date: May 2012
Location: Toughest lil' Town in Texas
Posts: 856
|
Winda Question ?
How do i get the whole winda assembly out of the door i need the sliding part that goes on the bottom part of the winda an i dont wanna tear it to hell to get it so can i get the less destructive way of gettin it please
|
|
|
|
09-21-2012, 08:50 PM
|
#2 |
|
I am a Referee of life.
Join Date: Jun 2000
Location: Greensboro N.C.
Posts: 13,992
|
Re: Winda Question ?
If you need to get to it but not remove it,you can just pull the door panel.Clean and lube everything while you're in there.If you need the rollers out of the track you will need to pull the vent window and sindow run.There are some good threads under window regulators.
__________________
The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion. You can't fix stupid,not even with duct tape. "My appearance is due to the fact that "GOD" does punish you for having too much fun!" Barrett-Jackson has perfected alchemy,they make rust into gold! "You can lead a horse to water but you can't saddle a duck" "Cleverly disguised as a 'Responsible Adult' "Sometimes your Knight in shining armor is just a retard in tinfoil" |
|
|
|
|
09-21-2012, 08:52 PM
|
#3 |
|
Account Suspended
Join Date: May 2012
Location: Toughest lil' Town in Texas
Posts: 856
|
Re: Winda Question ?
 yes sir i just need the rollers you think i can get a link to these threads please ?
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
