bracing for new floor ?

[blazer2007]

Getting ready to bring out the cut off tools on a 78 Blazer to notch a crossmember and put in some new floor where needed,mostly the back end and the sunken floor behind the dr.and pass. seats.I never thought about bracing until I read a thread on paint section.Was wondering if anyone had some input on where to brace as a Blazer would have different bracing points than a truck

[UKNOWME]

Originally Posted by blazer2007

Getting ready to bring out the cut off tools on a 78 Blazer to notch a crossmember and put in some new floor where needed,mostly the back end and the sunken floor behind the dr.and pass. seats.I never thought about bracing until I read a thread on paint section.Was wondering if anyone had some input on where to brace as a Blazer would have different bracing points than a truck

Are you using patch panels or did you find full sections? I need to replace the floor on my 78 from the firewall to the step up, both sides. No idea on the bracing question though

[68Timber]

I haven't read that thread about bracing but sounds like a good idea. Maybe two front/two rear on the same rib, per side? Three or four inch gussets like you would use on roll cage?

[blazer2007]

Originally Posted by UKNOWME

Are you using patch panels or did you find full sections? I need to replace the floor on my 78 from the firewall to the step up, both sides. No idea on the bracing question though

patch panels,mostly dr. side corners,back end and step section