|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
02-13-2013, 10:32 PM
|
#1 |
|
I am a Referee of life.
Join Date: Jun 2000
Location: Greensboro N.C.
Posts: 13,992
|
Re: custom steel lines ???
The best way I have found to unroll tubing is to lay the end on the ground and step on it.Keep the roll straight up and slowly unroll,straightening as you go.This seems to work well.I have also rolled out the length I needed and cut it,then left it lay and rolled the tube back and forth across the FLAT floor to get it straighter.
__________________
The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion. You can't fix stupid,not even with duct tape. "My appearance is due to the fact that "GOD" does punish you for having too much fun!" Barrett-Jackson has perfected alchemy,they make rust into gold! "You can lead a horse to water but you can't saddle a duck" "Cleverly disguised as a 'Responsible Adult' "Sometimes your Knight in shining armor is just a retard in tinfoil" |
|
|
|
| Bookmarks |
|
|
Hybrid Mode
