Bell tech drop spindles (issue?) - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Hybridcx · 07-31-2013, 12:32 PM

Hello everyone,
I picked up a set of belltech's 3120 drop spindles real cheap last week. I have a 72 GMC 1/2 ton (2wd) and it would seem these are ment to fit that year chev/gm. My issue is when I went to install them my outer tie rod ends were too small. I did a bit of digging and figured out I needed C20 tie rods. Does anyone know why this is? Is this typical? I just want to make sure this isnt going to cause me issues down the road. Thank you -Matt

**lolife99** · 08-08-2013, 06:28 PM

Did you ever get this resolved?

Custom 68 · 08-08-2013, 07:37 PM

Keep in mind there are differences between the years. These will all look about the same. I don't know the differences between the c10 and C20C20
Posted via Mobile Device

Hybridcx · 08-08-2013, 08:38 PM

Quote:

Originally Posted by lolife99

Did you ever get this resolved?

I used 72 c20 outers and that seemed to do it. Upper and lower ball joints seem to measure up properly. I have not driven the truck as it is still quite a far from being finished... We will see what happens.

07-31-2013, 12:32 PM	#1
Hybridcx Registered User Join Date: May 2012 Location: Abbotsford B.C Posts: 26	Bell tech drop spindles (issue?) Hello everyone, I picked up a set of belltech's 3120 drop spindles real cheap last week. I have a 72 GMC 1/2 ton (2wd) and it would seem these are ment to fit that year chev/gm. My issue is when I went to install them my outer tie rod ends were too small. I did a bit of digging and figured out I needed C20 tie rods. Does anyone know why this is? Is this typical? I just want to make sure this isnt going to cause me issues down the road. Thank you -Matt

08-08-2013, 06:28 PM	#2
lolife99 67-72 parts collector,… Join Date: Nov 2002 Location: Mid-MO Posts: 22,700	Re: Bell tech drop spindles (issue?) Did you ever get this resolved? __________________ Keith Convert to disc brakes. http://67-72chevytrucks.com/vboard/s...d.php?t=444823

08-08-2013, 07:37 PM	#3
Custom 68 Registered User Join Date: Nov 2001 Location: Springfield, MO Posts: 2,939	Re: Bell tech drop spindles (issue?) Keep in mind there are differences between the years. These will all look about the same. I don't know the differences between the c10 and C20C20 Posted via Mobile Device __________________ Dave 1968 Custom Chevy with turbo charged 5.3 gen III 4l80e swap 1967-71 GMC 3/4 ton long step 4x4 (not sure what year exactly?) "A good friend will bail you out of jail...but a true friend will be sitting next to you saying "that was frekin awesome". "If it doesn't fit force it...If it breaks then it needed to be replaced anyway!"



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.