|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-23-2003, 05:16 PM
|
#11 |
|
You get what you pay for
 
Join Date: Dec 1999
Location: Cherryville, NC
Posts: 4,798
|
The knock sensor must screw into the side of the block. This is the way it detects any spark knock, through the cylinder walls. I don't have any idea in which hole it would be on a stock TPI engine, but you only have 4 block drain holes, 2 on each side. The only limitation would be wire routing, if you are using the stock wiring.
Mike |
|
|
| Bookmarks |
|
|
Threaded Mode