|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-10-2004, 08:05 PM
|
#1 |
|
Junior Member
Join Date: Feb 2003
Location: L.I.,NY
Posts: 49
|
What size lowering block?
Looking for some info on lowering blocks.What detemines the size of the rear lowering block? In the front I have 21/2 drop spindles and will be installing airbags. The rear has a large
c-notch and will also have airbags.What size lowering block do you use? Thanks for the help, Pete |
|
|
|
01-16-2004, 10:56 AM
|
#2 |
|
GM ONLY BABY!!!
Join Date: Oct 2003
Location: Fort Wayne, IN.
Posts: 1,998
|
I would say 2 or 3". Deflate the bags and see how much clearance you have. There are a lot of guys on here who have fabbed up there own out of bar stock steel material. I wish I could just throw a set of blocks on mine. My 72 has rear leafs, sucks, sucks.
__________________
2 wrongs don't make a right, but 3 lefts do. 66 Chevelle Malibu 406ci, 573hp, 10.99@121mph 96 Chevy Silverado Z71 72 GMC 1500 Super Custom LS 6.0/4L65 on airride   http://www.cardomain.com/ride/707879...mc-c-k-pick-up |
|
|
|
|
01-16-2004, 10:58 AM
|
#3 |
|
GM ONLY BABY!!!
Join Date: Oct 2003
Location: Fort Wayne, IN.
Posts: 1,998
|
The lowering block goes on top of the truck arm, but below the axle tube. You probably already knew that though. Check out www.djmsuspension.com Good Luck!!
__________________
2 wrongs don't make a right, but 3 lefts do. 66 Chevelle Malibu 406ci, 573hp, 10.99@121mph 96 Chevy Silverado Z71 72 GMC 1500 Super Custom LS 6.0/4L65 on airride http://www.cardomain.com/ride/707879...mc-c-k-pick-up |
|
|
|
|
01-16-2004, 06:48 PM
|
#4 |
|
Registered User
Join Date: Jun 2002
Location: Tri Valley California
Posts: 792
|
I'm running bill turner 4 inch weld on blocks. I'm going to be laying frame on 20's with about a 29 inch tall tire!
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
