|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-22-2013, 06:41 AM
|
#1 |
|
Registered User
Join Date: Aug 2012
Location: nantucket,ma
Posts: 230
|
sheet metal bumper from LMC
opened the box for my new front bumper from LMC i noticed it was very thin i installed it to see how it would line up as i tightened the bumper bolts the bolt heads sunk into the bumper and left a dent around each square hole,i did not even tighten the bolts all the way.sad to say the good thing about this bumper is i can tighten it up,tweak, bend and adjust by hand.
Last edited by N2TRUX; 08-13-2013 at 10:53 AM. |
|
|
|
11-22-2014, 05:21 PM
|
#2 |
|
Registered User
Join Date: Dec 2011
Location: Green River, Wyoming
Posts: 69
|
Re: sheet metal bumper from LMC
I wish I would have seen this post earlier! I just had the exact same problem.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
