Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
08-27-2014, 03:16 AM | #26 |
Registered User
Join Date: Oct 2013
Location: Elkton
Posts: 693
|
Re: Mechanical clutch and header clearance?
I am going big block and nv4500 i bored the center of a lakewood blow proof out to fit drilled new mounting holes .I want to run mechanical clutch i guess ill need center dump headers?68 GMC1500 2wd
|
08-27-2014, 11:14 PM | #27 |
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
Re: Mechanical clutch and header clearance?
You should start another post on this, but here goes....if you run a mechanical linkage setup, I would bet that there are many long tube headers to fit your app. The deal on the LS swaps/stick shift, is that all off the headers(other than the streetrod shorties listed) are designed for the hyd clutch, & intrude on the space for the bell crank & linkage? I have not done your trans swap, so I can not give you the best advice I suggest, that you start a new post, for your app....not to be an azz who, but you may find a guy that has been there, for the "proper" help Longhorn
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
08-28-2014, 01:30 AM | #28 |
Registered User
Join Date: Oct 2013
Location: Elkton
Posts: 693
|
Re: Mechanical clutch and header clearance?
I was just thinking out loud no more and no less just speaking in generalities .I have a plasma and a welder .
|
01-09-2015, 12:56 AM | #29 |
Registered User
Join Date: May 2012
Location: Houston, tx
Posts: 99
|
Re: Mechanical clutch and header clearance?
I used 2000 camaro manifolds on a chevelle with a M20.
|
01-09-2015, 07:57 PM | #30 |
Registered User
Join Date: Oct 2013
Location: Elkton
Posts: 693
|
Re: Mechanical clutch and header clearance?
Thanks for the info.
|
Bookmarks |
|
|