|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-17-2004, 03:00 PM
|
#1 |
|
Garage Queen Material
Join Date: Oct 2002
Location: USA
Posts: 4,129
|
manifold vacuum fitting?
will the stock "t" manifold vacuum fitting clear with a holley carb?
|
|
|
|
02-18-2004, 09:49 AM
|
#2 |
|
Garage Queen Material
Join Date: Oct 2002
Location: USA
Posts: 4,129
|
ttt
|
|
|
|
|
02-18-2004, 12:22 PM
|
#3 |
|
Registered User
Join Date: Jan 2002
Location: Houston, TX
Posts: 2,144
|
are you talking about the vaccum fitting for the trans modulater thats behind the carb? if so then i wouldn't count on it fitting. i ran a 700 dp and an edelbrock intake before and had to use a 1 inch carb spacer for the rear bowl to clear the fitting. but different intakes locate the fitting at different heights so it depends on what intake your using
__________________
'51 F100, backhalf with a narrowed 9 and coil overs, 18.5" mickeys, monte front clip, +400" sbc in the works '05 1500 Crew Cab RIP '84 swb 5/7 drop, solid cammed 408 w/ fully ported dart heads, th350 w/ 10 inch hughes, 12 bolt w/ 3.73 richmonds and a locker '80 swb 4x4 in progress: 7" lift, 350 th350/np205, d44 and 1.5" ORD tie rod, 14BFF w/discs , armored diff covers, 40" MTR's |
|
|
|
|
02-18-2004, 02:35 PM
|
#4 |
|
Registered User
Join Date: May 2003
Posts: 50
|
T
Mine didn't clear, however, it did after I cut the horizontals down slightly.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
