SD two-rib rear carpet strip

[70gmcjimmy]

This carpet strip came from a 1972 GMC Jimmy. It has peeling chrome and surface rust. No rust holes or bends. One visible small ding on one rib, last photo. It will be shipped in a PVC tube to keep it from bending in shipment.

$75 plus shipping or best offer.

DAC

[70gmcjimmy]

Price lowered, $50 plus shipping.

DAC

[calgood]

Would you be willing to do $50 shipped? Can you get a pic down the length of the strip to show any bending?

[70gmcjimmy]

Originally Posted by calgood

Would you be willing to do $50 shipped? Can you get a pic down the length of the strip to show any bending?

No, sorry $50 plus shipping is low as I will go. Just the pvc tube and packaging is going to cost near 20 bucks and that is included in the $50 price. I will have 2 trips into town to get the pvc then one back to mail. I will just scrap it if I can't make a few bucks.

DAC

[calgood]

Fair enough. Can you tell me the shipping to 73012?

And can you post the pics down the length of it?

[1rippen6]

The plastic conduit for electrical wire is a little cheaper than PVC if you have access to it.

[70gmcjimmy]

Originally Posted by calgood

Fair enough. Can you tell me the shipping to 73012?

And can you post the pics down the length of it?

Thanks for the reply. Yes I will take a better pic down the length tomorrow after work, but as I said in the original post, it has no bends. The only other part I ever shipped this dimension was about $25 for freight USPS and that was just a few months ago. I will figure that closer tomorrow evening too.

Originally Posted by 1rippen6

The plastic conduit for electrical wire is a little cheaper than PVC if you have access to it.

Thanks for that advice!

DAC

[70gmcjimmy]

Originally Posted by calgood

Fair enough. Can you tell me the shipping to 73012?

And can you post the pics down the length of it?

Hello Calgood, Here are some pics and what shipping will be. I don't have the PVC so I went off the dimensions and weight of a tailgate to hatch strip I sent a while back. Since you are closer the shipping will be cheaper at $19.27. If it goes over that I will eat it.

Now on the pics, the bottom lip that goes against the floor is a little "wavy", and there is a bit of a crease between the screw holes in the last pic, also on the downward lip. I'm not sure how to get a better pic down the length.

I guess I would caution you against buying this if you are after a perfect piece that can be restored to original show quality. I do feel it can be made nice enough for a clean daily driver type truck.

If you are still interested, the total would be $69.27 shipped, including paypal fees too.

Thanks,
DAC