|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-22-2017, 03:20 PM
|
#1 |
|
Registered User
Join Date: Aug 2016
Location: Nicholson, Ga
Posts: 134
|
I need a measurement off your stepside truck
I'm trying to figure out how much wheel I can put on the back of my '65 Step side GMC but I don't have a bed to make measurements. Specifically I'm looking for someone to measure from the outside of the frame rail to the inside lip of the rear fender. I'm running an Explorer 8.8 so I can't use the stock axle back spacing
__________________
1981 K10 (4.8 / 4L60E swap) 1982 C10 (5.3 / 4L80E swap) 1985 C20 Suburban (454 / 4L80E) |
|
|
|
03-22-2017, 03:47 PM
|
#2 |
|
Registered User
Join Date: Jul 2014
Location: Michigan
Posts: 69
|
Re: I need a measurement off your stepside truck
Wheel well to wheel well is 50 inches if that helps
|
|
|
|
|
03-22-2017, 03:52 PM
|
#3 | |
|
Registered User
Join Date: Aug 2016
Location: Nicholson, Ga
Posts: 134
|
Re: I need a measurement off your stepside truck
Quote:
__________________
1981 K10 (4.8 / 4L60E swap) 1982 C10 (5.3 / 4L80E swap) 1985 C20 Suburban (454 / 4L80E) |
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
