Wonder What Under That Floor Brace?

[Kartch1]

Originally Posted by 1958Warrior

I would consider that a rust free floor, requiring only a couple of small patches.

Yea, it really wasn't in that bad of shape over all.
The truck is an Arizona desert vehicle so we can get dirt like that and have it sit for years and not cause rust. I never really noticed that the front brace was open to the outside on both ends. If I was going to keep the floor stock I would definitely be blowing out that area with compressed air every one and a while.

But if your going to remove it brace left to right and front to back and corner to corner, or it will spring and twist on you.

I got in a hurry back when I got the cab a few years ago and started cutting before i braced it up really good. So far I have been able to keep things good as far as the doors still fit well. I'm really hoping I didn't screw myself on this one. I'm more worried about windshield fitment when I get to that point. I really forget how lucky I am to have dry climate as far as rust goes. I see some rust in the passenger floor and my first instinct is, CUT IT OUT. Haha! I amazed at what some of you guys patch up to look like new.



You will want to blow out all the crud that has accumulated in the voids around the back cab mounts as well just as much back there as what you found in the front floor brace, a piece of wire clothes hanger will help get all the pebbles out.
Those areas were rusted through. I cut out the sheet metal behind the back cab braces, cleaned them out, treated the rust and patched it back up. I'm going to pour some Masters Series coating down the area as well as an additional sealer.


Hard to believe all that can find its way in the nooks and crannies, I had about 7lbs of red west Texas fine sand and, pebbles ,that was stuffed full inside mine.

Amazing the amount of stuff that builds up in there

The supports under the cab steps that run front to back trap the stuff in there and collects moisture and rust out the steps from below. your steps look like they have been remove but for those who have theirs it is a good Idea to clean those things out from time to time.

Yeah I'm replacing my steps. Not because of rust but they were bent to crap. So bad I wouldn't have been surprised if the cab was a little tweaked just from that.