![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
![]() Join Date: Dec 1999
Location: TX
Posts: 1,670
|
WTB - Inline 250 Intake Manifold PCV Valve Fitting
![]() ![]() Out of my 3 intake manifolds...only 1 had this fitting and I broke it trying to get it out. |
![]() |
![]() |
![]() |
#2 |
Senior Member
![]() Join Date: Dec 2013
Location: Gods country East,Tn
Posts: 8,545
|
Re: WTB - Inline 250 Intake Manifold PCV Valve Fitting
I have 4 , I'll try some pb blaster and a little heat to see if I can get one out intact .
![]() |
![]() |
![]() |
![]() |
#3 |
Senior Member
![]() Join Date: Dec 2013
Location: Gods country East,Tn
Posts: 8,545
|
Re: WTB - Inline 250 Intake Manifold PCV Valve Fitting
Ok , I have one for you ... That is NOT a screwed in fitting it is a pressed in fitting It takes heat and penetrant to pull it out working it slowly from side to side . I'll post pictures as soon as it cools down ...
anyone with a hard to find vacuum leak should look at this fitting the one I pulled had been slathered with red rtv sealant . ![]() |
![]() |
![]() |
![]() |
#4 |
Senior Member
![]() Join Date: Dec 2013
Location: Gods country East,Tn
Posts: 8,545
|
Re: WTB - Inline 250 Intake Manifold PCV Valve Fitting
1st pic shows NO threads it's a pressed in fitting
![]() I bead blasted it to clean it up , You can see NO threads ![]() ![]() ![]() $10.00 to Paypal kdwholesaletools@gmail.com ![]() |
![]() |
![]() |
![]() |
#5 |
Senior Member
![]() Join Date: Dec 1999
Location: TX
Posts: 1,670
|
Re: WTB - Inline 250 Intake Manifold PCV Valve Fitting
Sent you paypal.
That one looks a little different than what I had. Mine just came straight out the top with no 'angled block'. I could have told you the non threaded part...since I have 2 manifolds that don't have anything at all in them. I'll definitely put some sealant on it when I reinstall. |
![]() |
![]() |
![]() |
Bookmarks |
|
|