|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-10-2018, 11:00 PM
|
#1 |
|
Registered User
Join Date: May 2016
Location: Fort Mohave, AZ
Posts: 370
|
Neutral Safety Switch for a 700R trans
Starting to put everything back together on my 70 GMC. I have a 700R installed and I'm trying to adjust the NSS. The current NSS is for the 350 trans. I can get 'Park' and 'Reverse' adjusted but my 'Netural' is falling between OD.
Does anyone make a NSS that will place neutral at 'N' for a 700R trans?
__________________
1970 GMC 2500 700R Trans, RideTech 4 link rear suspension, air bagged on all four corners, factory upper/lower A-Arms, 2 inch drop spindles. 350 SBC 300hp Weiand Supercharger FiTech 30004 EFI |
|
|
|
02-12-2018, 11:27 PM
|
#2 |
|
Registered User
Join Date: Oct 2006
Location: Dundee, Oregon
Posts: 311
|
Re: Neutral Safety Switch for a 700R trans
I'm using a stock switch with a 4L60E. Works fine.
|
|
|
|
|
02-12-2018, 11:46 PM
|
#3 |
|
Who Changed This?
 
Join Date: Jan 2013
Location: Simi Valley, CA
Posts: 10,747
|
Re: Neutral Safety Switch for a 700R trans
I had a 700 (4R) in my '68 Skylark (Chevy engine) and the stock Super Turbine 300 trans shifter worked fine. Couldn't hammer it into low, though. Didn't need to. It was a real tire twister.
__________________
~Steven '70 Chevy 3/4T Longhorn CST 402/400/3.56 Custom Camper Simi Valley, CA |
|
|
|
|
02-14-2018, 02:17 PM
|
#4 |
|
Registered User
Join Date: Jan 2011
Location: Chattanooga, TN
Posts: 2,171
|
Re: Neutral Safety Switch for a 700R trans
Can you use one for a square body or later van? My '83 K20 has a factory 700R4 and like '88 Vans had them.
__________________
'83 K20-TPI '73 C10 '79 C10-ex-diesel(SOLD) '07 Tahoe(Son driving) '14 Suburban-DD '71 C10-current project |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
