|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-15-2018, 03:14 AM
|
#1 |
|
Registered User
Join Date: Feb 2017
Location: Torrance, CA
Posts: 56
|
shift selector bushing/bolt removal
Hey all, I am installing a Lokar ACA-1800 shift linkage kit, however I am not sure how I should remove the bolt/bushing on the shift selector (see atatched image). This bolt just spins and it looks like the only way to remove it is to cut it off...is that correct? Thanks in advance!
|
|
|
|
03-15-2018, 05:23 PM
|
#2 |
|
One foot in front of the other
 
Join Date: Aug 2008
Location: Parrottsville, TN
Posts: 5,442
|
Re: shift selector bushing/bolt removal
Is there a c-type clip on the head side?
|
|
|
|
|
03-15-2018, 11:00 PM
|
#3 |
|
Registered User
Join Date: Feb 2017
Location: Torrance, CA
Posts: 56
|
Re: shift selector bushing/bolt removal
After looking again I believe there is, thank you! I was trying to figure out how I was gonna get a cutoff wheel in there haha
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
