|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-16-2004, 03:07 PM
|
#1 |
|
Registered User
Join Date: Jul 2003
Location: north of Phx AZ about 30 miles
Posts: 698
|
Need meas. for side trim on '67 lwb
Does anybody happen to have some measurements for the side trim on a long bed, '67 C-10? I need to finish putting on my trim and the bedside I put on does not have the trim holes. I have them on the other side, but I don't want to remove the trim to measure them.
__________________
Andy,Phx AZ '67 C-10 (Ahhh, done at last. Well there is that disk front end I want to put in and...) "23 C-Cab-sold '48 Ford 8N tractor(still working) '67 Scout(Now on the road) '70 MG B.-sold |
|
|
|
05-16-2004, 10:55 PM
|
#2 |
|
Senior Member
Join Date: Jun 2002
Location: Augusta Missouri
Posts: 804
|
I have looked at several different trucks and they seem to have the trim on different ways. Does yours follow the bed line, or is it below it ? I saw one truck that actually slanted lower the farther back it went. I am going to put trim on mine and need to know the correct way and location of holes.Thanks
|
|
|
|
|
05-16-2004, 11:41 PM
|
#3 |
|
Registered User
Join Date: Jul 2003
Location: north of Phx AZ about 30 miles
Posts: 698
|
MIne follows the bed line, 'bout a quarter of an inch below it. I guess I could measure inside of the bed side to get the spacing. Does anyone know the hole size I need to drill??
Thanks, Andy
__________________
Andy,Phx AZ '67 C-10 (Ahhh, done at last. Well there is that disk front end I want to put in and...) "23 C-Cab-sold '48 Ford 8N tractor(still working) '67 Scout(Now on the road) '70 MG B.-sold |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
