![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Nov 2014
Location: Lynnwood, Wa
Posts: 16
|
72 rear frame/bumper help
Hey folks,
I have a 72 Blazer that is almost back in one piece and I need a little help figuring out how to remedy some PO handiwork. Looks like a different rear bumper was fitted on at some point and I’m not sure what it’s supposed to look like back there (no rear bumper when I bought it). The ends look to be cut off and brackets were “welded” on along with a trailer hitch which is also bolted and welded in. What would you recommend I do to fix this? I’m very much learning as I go. Thanks! |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Dec 2018
Location: Weiser Idaho
Posts: 68
|
Re: 72 rear frame/bumper help
This is a 72 Blazer frame with a pickup bumper bolted to it. Just ignore the bumper and the two bolts. What you will see is an un-cut rear frame with the end tab bent out. If that tab was @ 90 degrees to the frame it would be correct. I just have to bend it back. You can see the rear frame body mount hole as reference. Hope that helps. Jeff |
![]() |
![]() |
![]() |
Bookmarks |
|
|