|
07-17-2019, 06:27 PM
|
#1 |
|
Registered User
Join Date: Oct 2018
Location: Ontario Peterborough
Posts: 804
|
Question
How close can your rear axle be to the frame without getting into a frame notch on a 82 c10
I need another inch and a half lower |
|
|
|
07-17-2019, 06:41 PM
|
#2 |
|
Post Whore
  
Join Date: May 2015
Location: Alabama
Posts: 14,670
|
Re: Question
I would say a couple or 3in at the least....heavy loads or rough roads will have effect on it as well....
__________________
Mongo...aka Greg RIP Dad RIP Jesse 1981 C30 LQ9 NV4500..http://67-72chevytrucks.com/vboard/s...d.php?t=753598 Mongos AD- LS3 TR6060...http://67-72chevytrucks.com/vboard/s...34#post8522334 Columbus..the 1957 IH 4x4...http://67-72chevytrucks.com/vboard/s...63#post8082563 2023 Chevy Z71..daily driver |
|
|
|
07-18-2019, 06:47 PM
|
#3 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,066
|
Re: Question
I like 3" before anything touches. You can get by with less but for a trouble free, no contact suspension I would shoot for the 3" number.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
07-18-2019, 09:31 PM
|
#4 |
|
Registered User
Join Date: Dec 2012
Location: Temple City
Posts: 3,628
|
Re: Question
If you wanna run close to the frame. Get 2015+ Silverado 1500 bump stops.
They are soft. When I removed my rear block, and added longer shackles I had 1/2 inch travel left. So before I cut out that stand I was constantly on the bump stops,and honestly. It did not ride 1/2 bad. So I would get a pair, and weld them in so you have a 1- 1 1/2" of travel before you hit them. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
