|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-30-2020, 07:02 PM
|
#1 |
|
Registered User
Join Date: Jan 2012
Location: el campo texas
Posts: 322
|
tailight wires
what do you guys use to cover your wires from taillight to bed
|
|
|
|
05-01-2020, 07:24 AM
|
#2 | |
|
Registered User
Join Date: Nov 2015
Location: Jemez Springs, NM
Posts: 435
|
Re: tailight wires
Quote:
I bent some stainless tubing (5/16 i think) and ran through the bed and flared at the tail light. Stainless washers on each side of the tube going through the bed siliconed in place |
|
|
|
|
|
05-01-2020, 03:16 PM
|
#3 |
|
Registered User
 
Join Date: Jul 2007
Location: Toppenish, WA
Posts: 15,710
|
Re: tailight wires
In the past I have seen guys use chrome plated copper tubing intended for water supply lines to faucets that you find in the plumbing section. You would have to check to see if it is bendable though. I've seen some use the flexible stainless water supply lines too.
That stainless line that Jemzcrusher showed is about as clean and sanitary as you can ever find though.
__________________
Founding member of the too many projects, too little time and money club. My ongoing truck projects: 48 Chev 3100 that will run a 292 Six. 71 GMC 2500 that is getting a Cad 500 transplant. 77 C 30 dualie, 454, 4 speed with a 10 foot flatbed and hoist. It does the heavy work and hauls the projects around. |
|
|
|
|
05-01-2020, 06:58 PM
|
#4 |
|
Registered User
Join Date: Nov 2013
Location: Show Low, Arizona
Posts: 778
|
Re: tailight wires
welded a d JIC Male fitting onto a stock tail-light bracket, then bent up a piece of -6 stainless tube as a conduit.
 the fitting on the bracket. I trimmed the screws and used acorn nuts after this pic 
|
|
|
|
|
05-01-2020, 10:16 PM
|
#5 |
|
Registered User
Join Date: Sep 2014
Location: USA
Posts: 2,249
|
Re: tailight wires
I just went with corrugated split loom plastic tubing.
But if you want something fancy, how about braided stainless headlight conduit?
__________________
1951 Chevy Panel Truck Last edited by MiraclePieCo; 05-04-2020 at 04:08 AM. |
|
|
|
|
05-04-2020, 11:12 AM
|
#6 |
|
Registered User
Join Date: Dec 2011
Location: Belgium
Posts: 82
|
Re: tailight wires
I'm currently looking at https://www.techflex.com/ for their high temperature resistant sleeves, to cover some of my cooler lines and wires around the engine...
They also have metalic sleeves with 'chrome' look :  
__________________
'56 Chevy stepside shortbed SBC350 - TH350 12-bolt rear |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
