|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-12-2020, 06:26 PM
|
#5 |
|
Moderator
 
Join Date: Jun 2017
Location: Cherryville, NC
Posts: 2,204
|
Re: 2003 LQ4 Cam Housing 1st or 2nd Design
Unless the cam bearings in the block are damaged, I would suggest leaving them alone...
Be aware that factory line bores the cam tunnel after the bearings are installed due to core shift issues...or at least what a lot of info suggests... So if you see a cross hatch on the bearing surfaces it is not a failure point... 
__________________
Family and country before all others... 2006 Chevy Silverado (Daily Driver) 2012 Chevy Equinox 
|
|
|
| Bookmarks |
| Tags |
| 6.0l, cam bearing, cam bore, cam design, cam housing |
|
|
Threaded Mode