Hardware for Door Vent Window Frame? - The 1947 - Present Chevrolet & GMC Truck Message Board Network



Register or Log In To remove these advertisements.

		The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1960 - 1966 Chevrolet & GMC Pickups Message Board
Hardware for Door Vent Window Frame?

Site Merchandise

Thread Tools

Display Modes

01-07-2021, 10:23 AM

SCOTI

Registered User

Join Date: Apr 2001

Location: DALLAS,TX

Posts: 22,080

Re: Hardware for Door Vent Window Frame?

Quote:

Originally Posted by PGSigns

Pulled one of mine and it looks like 8X5/8". You can test the length with the vent window out. They need to go pretty much all the way in and not bottom out. The three tabs pull up flush to the inside of the door.
Jimmy

This seems correct. I had to use one longer as one hole just didn't seem to have adequate 'bite' @ the shorter length. Seems I used 3/4 & 1qty 1" (for the one hole). I used beveled SS screws as well.

__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG

Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....

Cubic inches is like Indiana Jones with a cheap pistol.

Bookmarks

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 06:05 PM.

Register or Log In To remove these advertisements.