|
05-08-2004, 09:47 AM
|
#1 |
|
Registered User
Join Date: May 2003
Location: Il
Posts: 90
|
Drive Shaft
My truck came with a I-6 and 350 turbo tranny. I recently installed a 350 with a 700r4 tranny. I also lowered my truck 5 inches with shackles and hanger kit. I went to install my drive shaft and it is about two inches to long. Did I do something wrong or should I get a different drive shaft?
__________________
83 Chevy SWB http://www.cardomain.com/id/letheridge |
|
|
|
05-08-2004, 10:49 AM
|
#2 |
|
Registered User
Join Date: Oct 2002
Location: The Netherlands
Posts: 118
|
When I swapped my 350 trans for the 700r4 I had to shorten the driveshaft about 2 or 3 inches.Brought it to a shop to shorten and balance it.
__________________
*Andre* 1984 C10 SWB, 350/700R4 
|
|
|
|
|
05-08-2004, 10:55 AM
|
#3 |
|
Registered User
Join Date: Mar 2003
Location: Liège , Belgium
Posts: 263
|
Just did the same for my Burb , it costed me for about 200€ ( 240 US$ )...
 but I have a one year warranty..
__________________
1982 Suburban 2WD , 260ci Olds engine,TH400 , will get a 1979 front clip , might be ready in ... 2016 1985 Chevy Van ( 305/350 ) , "Kellogg" equipped , my actual D.D. 1960 Girl Friend , frame still good , body has some dents |
|
|
|
|
05-08-2004, 04:25 PM
|
#4 |
|
Registered User
Join Date: Nov 2002
Location: lacenter, washington
Posts: 718
|
When I lowered my 78 with a 4/6 drop I had to shorten my driveline 1". It only costed me 65 dollars to have it cut welded and balanced. lowering and raising a trucks effects the angle of the driveshaft.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
