|
06-22-2004, 10:12 AM
|
#1 |
|
Registered User
Join Date: Oct 2003
Posts: 5
|
Axle question
I have removed my driver side front axle shaft due to breakage and I now need to move the truck and do not have replacement parts yet. I will have to move the truck before the parts get here. So my question is can I put the rotor and stuff back on and mount the wheel so the truck can roll, so I can put it on a trailor to move it. Thanks for any help.
|
|
|
|
06-22-2004, 10:19 AM
|
#2 |
|
user # 2756
 
Join Date: Jun 2001
Location: Chesapeake, Virginia
Posts: 4,612
|
You can, but it sucks to put it back together just to tear it down again. Your not driving, right? Just putting it on a trailer? The inner axle keeps the gear oil in the pumpkin, with out it the oil will run out the end of the axle tube.
__________________
1970 K25, 8' stepside bed 350/465/205 44 up front, 60 in the rear 4.10s rolling on 33" Dunlop MTs 1986 K5, 350/465/208 Dana 60/14 bolt from a cucv 36" Super Swampers TSL/SX 1983 K20 w/ CUCV axles, 350/700R4/208 sitting on 37" Goodyears 1986 M1031 6.2 diesel, TH400/NP205 locker in the rear and a LS in the front, all stock for now..... 1986 K30, 350/400/205 dana 60 and 14 bolt. I kept the drivetrain. Body/bad and chassis are gone. 1981 K30, 350/465/205 dana 60 and dually 14 bolt. Has a G80, and a flat bed. Going to replace the flat bed. 1985 K20, 350/400/208 10 bolt and SF 14 bolt. I wonder where I can find some 1 tons. Hmmmmm 
|
|
|
|
|
06-22-2004, 10:25 AM
|
#3 |
|
Registered User
Join Date: Oct 2003
Posts: 5
|
NO driving just putting on trailor. Yea the putting back together to tear it down again is the story of my life with this truck. Thanks for info.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
