Anyone have a manual for 67 C10?

[johnymac]

I have a bit of a problem, I think?
I am putting the upper control arm back on the truck, I have replaced the shaft and bushings.

I have a 1967 Chevrolet truck Chassis Service manual. It directs me to center the shaft then torque to 160 lb ft.
The final position should be 2 7/32" from the center of the stud to the outter edge where the nut attaches, on the right. I have 2 7/32" on the right, but have 2 5/16" on the left. I seem to be an 3/32" off. Not sure what to do. My manual only gives measurements for the right side. Maybe I am on, but this would mean that the shaft is no longer centered now.

Does anyone have a manual that might be a little more informative?
Has anyone done this recently and remember the measurements? Is being 3/32" off a bad thing?

Appreciate any help here.

Thanks.

[This message has been edited by johnymac (edited May 14, 2002).]