Running motor without harness - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Alexis · 07-23-2005, 11:26 PM

So i want to get the frame finished to the point I can drive her around the block. The problem I face is I don't want to hook-up an O.E harness, I rather just make one with the wires I need so i can rip her apart on and off. Anyone got any the steps to do this? I got some idea but rather get a list going of "TO-DO" list before i start on this. I want to get my mind of the body work

I got an HEI
1-wire alternator

Also I had to 2 row radiator now I got a 4 row. Do i have to mod the bottom mounts? or are there 4 row mounts for the bottom and top?

Tips, ideas, and diagrams would be great.

thanks
Alex

07-23-2005, 11:26 PM	#1
Alexis Member since 2000 Join Date: Dec 2000 Location: Mountain View Ca / Mexico Posts: 7,874	Running motor without harness So i want to get the frame finished to the point I can drive her around the block. The problem I face is I don't want to hook-up an O.E harness, I rather just make one with the wires I need so i can rip her apart on and off. Anyone got any the steps to do this? I got some idea but rather get a list going of "TO-DO" list before i start on this. I want to get my mind of the body work I got an HEI 1-wire alternator Also I had to 2 row radiator now I got a 4 row. Do i have to mod the bottom mounts? or are there 4 row mounts for the bottom and top? Tips, ideas, and diagrams would be great. thanks Alex Last edited by Alexis; 07-23-2005 at 11:28 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.