|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-31-2005, 12:35 AM
|
#1 |
|
Registered User
Join Date: Jan 2005
Location: Nicholasville, KY 40356
Posts: 461
|
Speed Density TPI Intake from 92 Z-28
Mods- Other thread was deleted. No cross posting....jt
I am now parting the intake, if there is any interest in the following parts LMK. includes: Intake Base with EGR $50.00 Fuel Rails $25.00 Both Left and Right runners $25.00 Thermostat Housing $10.00 Distributor cover $15.00 Throttle Cable bracket $10.00 Map sensor bracket $10.00 Bolts $10.00         
__________________
2011 Camaro 1SS LS3/6 Speed Last edited by jtmiller92; 01-05-2006 at 12:03 AM. |
|
|
|
01-05-2006, 12:01 AM
|
#2 |
|
Registered User
Join Date: Jan 2005
Location: Nicholasville, KY 40356
Posts: 461
|
Re: Speed Density TPI Intake from 92 Z-28
OK, Ended up parting it out. I have sold the injecors, plenum, and throttle body. still have everything else listed above.
__________________
2011 Camaro 1SS LS3/6 Speed |
|
|
|
|
01-05-2006, 09:42 AM
|
#3 |
|
Slots go on anything!
Join Date: May 2003
Location: Richardson, TX
Posts: 5,957
|
Re: Speed Density TPI Intake from 92 Z-28
You might try the Monte Carlo SS forums. They like to do the TPI swap. I have a couple of pretty nice MAF setups, I figured I would try them there first.
__________________
1974 Jimmy- 5.3/4L80e/NP241 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
