|
05-23-2006, 11:20 PM
|
#1 |
|
Registered User
Join Date: Dec 2005
Location: Bogalusa Louisiana
Posts: 146
|
trailing arms
Hello can ya guys tell me how to get the bushings out of the trailing arms so i can replace them?
|
|
|
|
05-23-2006, 11:27 PM
|
#2 |
|
Registered User
Join Date: Apr 2004
Location: arkieland
Posts: 1,070
|
Re: trailing arms
I set them on fire w/a torch, let burn a while, then they push right out into a flaming ball on the ground. if you are using urethane, all you gotta do is scrape around inside w/a carpet knife. if you are using OE rubber kind, you have to collapse the metal shell & remove it. brian
|
|
|
|
|
05-23-2006, 11:48 PM
|
#3 |
|
Cantankerous Geezer
Join Date: Aug 2002
Location: Bel Aire, KS
Posts: 6,264
|
Re: trailing arms
That old rubber is hard. I agree with the blowtorch, it softens them.
__________________
Fred There is no such thing as too much cam...just not enough engine. 
|
|
|
|
|
05-24-2006, 09:40 AM
|
#4 |
|
Registered User
Join Date: Mar 2003
Location: Northern Illinois
Posts: 2,181
|
Re: trailing arms
I took it to a shop with a press, and they were able to push the old ones out and install the new ones in a couple of minutes.
B |
|
|
|
|
05-25-2006, 11:19 PM
|
#5 |
|
Registered User
Join Date: Nov 2004
Posts: 31
|
Re: trailing arms
I just had mine done by a shop for $30.00, which included removal of the entire bushing (inner sleeve, rubber & outer sleeve) & installing the new ones. The manual has instructions for proper removal for what it's worth.
|
|
|
|
|
05-30-2006, 10:16 AM
|
#6 |
|
Registered User
Join Date: Dec 2005
Location: Louisiana
Posts: 3
|
Re: trailing arms
I Put Them In A Vice An With A Hammer Beat Them Out, An Installed Them With A Bolt An Washers ,tighting The Bolts To Push Them In Place, Around 30 Min.
|
|
|
|
|
05-30-2006, 11:52 AM
|
#7 |
|
67 is sold
Join Date: Apr 2001
Location: Troy, Michigan
Posts: 6,733
|
Re: trailing arms
I burned my old bushings out.
New bushings went right in with a littl coaxing 
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
