The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 06-23-2007, 09:08 PM   #1
North Idaho Rancher
Registered User
 
North Idaho Rancher's Avatar
 
Join Date: Jan 2004
Location: Troy
Posts: 3
My Dumb Question for The Day!

Howdy all,
How do I remove the trim piece above the glove box on my '82 K30 with A/C? I hope I don't have to pull the dash pad......

TIA,

Scott
North Idaho Rancher is offline   Reply With Quote
Old 06-23-2007, 09:18 PM   #2
DROPPED15
HALF ASSER
 
DROPPED15's Avatar
 
Join Date: Feb 2007
Location: IN THE GHETTO
Posts: 204
Re: My Dumb Question for The Day!

Yep!it's Attached To The Dash Pad From The Back Side.
__________________
DROPPED15 is offline   Reply With Quote
Old 06-23-2007, 11:32 PM   #3
benoit454
Chris
 
benoit454's Avatar
 
Join Date: Nov 2004
Location: Monaville, WV
Posts: 3,737
Re: My Dumb Question for The Day!

exactly but the pad isn't hard to remove.

it has one phillips screw in the side where the door open on the passenger side.

I think 4-6 7mm screws on the bottom of the pad between that trim piece and the metal dash, and then you need to remove the top 4 phillips head screws from the part around the guages, and I usually remove the ones down both sides of it too.

Just a tip though, it makes it alot eaiser to remove and install if you take the guage bezel(part around the guages off)

Just remove the radio knobs and nuts if you have the old am/fm like stock, or slide your cd player out, unplug the antenna and speakers wires, power and ground wires, remove 4 screws that are 2 on both sides of the steerin column, they hold that lower column cover on, take it off, remove any remaining screws from the bezel around the guages if any you left from before, and it should slide on out. if it has the duct over the heater controls/ vent over the controls, that is sometimes hard to workout of there.

Once remove lift up on the pad, and slide towards you, should slide out easy.

Then remove the panel nuts from the back of that trim piece, at least 6 I think on it. I used to know what size they are but now i forget, 7/16 or 1/2 or somewhere in that area I think.
__________________
Chris



GIT R DONE!!!!!!

Check out all our rides,
http://www.cardomain.com/id/benwa454
benoit454 is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:31 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com