|
|
|
08-06-2007, 03:47 PM
|
#1 |
|
Cochino_Racing_909
Join Date: Oct 2006
Location: California
Posts: 280
|
What is the best way
Hey Roomies I got a question!
I just bought a High energy polyy kit for my Blazer whats the best way to go about installing it? Also What is the best way to untack those welds on the bolts so I can get new ones? |
|
|
|
08-06-2007, 04:04 PM
|
#2 |
|
Post Whore
 
Join Date: Feb 2000
Location: Rose Hill, KS, USA
Posts: 12,686
|
Re: What is the best way
It is best to do one side at a time. I used a cutoff wheel and carefully ground the tack weld off of each bolt. A few of the bolts I had to grind the complete head of the bolt off and punch it through the floor to remove it. I also had to use a v-chisel on my air hammer to cut one of the metal sleeve on the passenger side bolt near where you feet go.
Use a jack or two to lift one side of the vehicle and get the old rubber out and put the new poly mounts in place. I believe I have heard you should put a little lub on the poly mounts to cut down on squeeks.
__________________
1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14 |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
