|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-06-2007, 08:43 PM
|
#1 |
|
Registered User
Join Date: Dec 2004
Location: Stephenville, Texas
Posts: 420
|
HELP!! Temp Gauge wont work.
Okay I am about at my wits end. I cannot get my temp gauge to work. I have replaced sending unit, wires to printed circuit, printed circuit and new gauge. It still pegs out on H befor I can even start it. Can anyone help??
__________________
72 Super Cheyenne lwb 4X4 Ocra / White  88 Chevy 1 ton Dumptruck 88 Chevy 1ton Flat bed 4X4 white
|
|
|
|
08-06-2007, 09:33 PM
|
#2 | |||
|
Union Electrician
Join Date: Feb 2005
Location: Louisville, Ky.
Posts: 3,354
|
Re: HELP!! Temp Gauge wont work.
If you are certain there is not a short in the wire from the sending unit to the gauge, then you need to change the resistor, or porcelian piecee on the rear of the gauge, you can get them form the vendore for around $10..Randy
__________________
 69 Custom-10 SWB FLEETSIDE  350/350 TH Dropped 3.5/5.5"Help support the board->HERE Board vendors -> Vendors list Zip:40272 Big Sandy Survivor... Quote:
Quote:
Quote:
|
|||
|
|
|
|
08-06-2007, 10:15 PM
|
#3 |
|
Registered User
Join Date: Jun 2007
Location: Kaufman TX
Posts: 160
|
Re: HELP!! Temp Gauge wont work.
The new guage from LMC don't use the resistor. I install one on Sunday and I am having the same problem, I am changing out the printed circuit board next. You might check if you have 12 Volts on the guage.
|
|
|
|
|
08-07-2007, 08:42 AM
|
#4 | |
|
Registered User
Join Date: Dec 2004
Location: Stephenville, Texas
Posts: 420
|
Re: HELP!! Temp Gauge wont work.
My new gauge is from LMC but I used the resistor I guess I should have read the instructions DUH! Thanks for the Help!
Quote:
__________________
72 Super Cheyenne lwb 4X4 Ocra / White 88 Chevy 1 ton Dumptruck 88 Chevy 1ton Flat bed 4X4 white
|
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
