Autometer Guage install.... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

NF65Fleetside · 03-27-2008, 09:47 PM

Hey guys, just wanted to know if any of you had a wiring diagram or could share a bit of info on where you tapped your guages into. Also anyone know why maybe my fuel guage only goes to half full when the tank is definetly full?

64GMCHorsepower · 03-27-2008, 10:46 PM

Do you have the right sending unit for the gauge? Some read with a different Ohm range.....

psychorodder · 03-28-2008, 12:04 AM

Had the same problem on my autometer guage it was the ground ,I ran a ground from back of guage to the sending unit on tank then to frame.

NF65Fleetside · 03-28-2008, 08:10 AM

Quote:

Originally Posted by psychorodder

Had the same problem on my autometer guage it was the ground ,I ran a ground from back of guage to the sending unit on tank then to frame.

so two ground wires then and it fixed the problem? Ill try it in the morning and see if it works.

03-27-2008, 09:47 PM	#1
NF65Fleetside Registered User Join Date: Feb 2007 Location: Los Angeles Posts: 674	Autometer Guage install.... Hey guys, just wanted to know if any of you had a wiring diagram or could share a bit of info on where you tapped your guages into. Also anyone know why maybe my fuel guage only goes to half full when the tank is definetly full?

03-27-2008, 10:46 PM	#2
64GMCHorsepower Justified! Join Date: Apr 2007 Location: Valencia, Ca Posts: 1,366	Re: Autometer Guage install.... Do you have the right sending unit for the gauge? Some read with a different Ohm range..... __________________ Chad 1964 GMC Fleetside Shortbed....350/700R4 tranny

03-28-2008, 12:04 AM	#3
psychorodder Registered User Join Date: Jan 2007 Location: ga Posts: 37	Re: Autometer Guage install.... Had the same problem on my autometer guage it was the ground ,I ran a ground from back of guage to the sending unit on tank then to frame.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.