4WD Selector Lever Light Replacement? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

GG_Blaisdell · 01-29-2009, 03:19 PM

Hello folks,

I have recently discovered the light/bulb that illuminates my transfer case selector, or 4wd lever inside the cab on the floor (i.e. 2 wheel hi, 4 wheel low etc.) has ceased burning. Any tips on replacing said bulb? I remember it functioning but there is no bulb visible inside the little plastic window.

The truck is an '87 K5 350.

Thank you for any help or information!

Jonboy · 01-29-2009, 10:56 PM

there are 2 screws in the front and 2 in the rear of the black console. Remove them, and lift up. You will see the wiring and the bulb.

GG_Blaisdell · 01-30-2009, 07:31 PM

Thank you Jonboy. Took care of the bulb this morning, bulb no. 194, pack of two cost $2.59 at NAPA. Thanks again.

01-29-2009, 03:19 PM	#1
GG_Blaisdell Registered User Join Date: May 2007 Location: USA Posts: 16	4WD Selector Lever Light Replacement? Hello folks, I have recently discovered the light/bulb that illuminates my transfer case selector, or 4wd lever inside the cab on the floor (i.e. 2 wheel hi, 4 wheel low etc.) has ceased burning. Any tips on replacing said bulb? I remember it functioning but there is no bulb visible inside the little plastic window. The truck is an '87 K5 350. Thank you for any help or information!

01-29-2009, 10:56 PM	#2
Jonboy Slots go on anything! Join Date: May 2003 Location: Richardson, TX Posts: 5,957	Re: 4WD Selector Lever Light Replacement? there are 2 screws in the front and 2 in the rear of the black console. Remove them, and lift up. You will see the wiring and the bulb.

01-30-2009, 07:31 PM	#3
GG_Blaisdell Registered User Join Date: May 2007 Location: USA Posts: 16	Re: 4WD Selector Lever Light Replacement? Thank you Jonboy. Took care of the bulb this morning, bulb no. 194, pack of two cost $2.59 at NAPA. Thanks again.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.