|
04-21-2009, 03:19 PM
|
#1 |
|
Enjoying left field
Join Date: Jun 2008
Location: Dillon Montana
Posts: 900
|
draglink welding
Is the center link cast? Would it be OK to weld on it? I need to make a new center link and I was thinking of cutting the ends of the stock one, and useing a piece of 1 1/4 DOM.
|
|
|
|
04-23-2009, 11:08 AM
|
#2 |
|
Happy to be here
 
Join Date: Mar 2000
Location: Cypress, TX
Posts: 39,021
|
Re: draglink welding
Any of you welding experts have an answer?
__________________
Follow me on Facebook and Instagram @N2trux.com Articles- "Jake" the 84 to 74 crewcab "Elwood" the77_Remix 85 GMC Sierra "Scarlett" "Refining Sierra" |
|
|
|
|
04-23-2009, 11:22 AM
|
#3 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,068
|
Re: draglink welding
I know drag-links can be welded on because I've seen pics on the net where people have modified theirs. I also know (from researching this mod) it's not acceptable in the eye's of many state DPS officers.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
04-23-2009, 07:57 PM
|
#4 |
|
Enjoying left field
Join Date: Jun 2008
Location: Dillon Montana
Posts: 900
|
Re: draglink welding
I think I'm gonna go a different way with it. I'm gonna use all heim joints instead.
|
|
|
|
|
04-23-2009, 08:14 PM
|
#5 |
|
Registered User
Join Date: Jan 2008
Location: Phx,AZ
Posts: 352
|
Re: draglink welding
Iv seen off road shops weld on the to add steering stabliser (sp?)
__________________
1973 C10 "Chain Reaction" Street Trucks cover Feb 2012 2013 Silverado 1964 Cadillac |
|
|
|
|
04-23-2009, 08:42 PM
|
#6 |
|
Registered User
Join Date: Nov 2008
Location: Windsor, CA
Posts: 500
|
Re: draglink welding
I would just run rod ends like you said, and build one from scratch. It will look better anyways.
But I have modified a few. Most of them are cast steel as far as I know, the ones I did where. I basically clean them (sand blast) and then grind them until they are smooth and the cast texture is gone. I bevel everything pretty deep, and pre heat them with a torch and TIG them with a 312 stainless rod.
__________________
If you can find it cheaper, I can fix it! |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
